Knowledge Base Article
CutStudio
Title
Why do I need to "UNSETUP" after each cut job finishes?
Summary
I have to "unsetup" after each cut job otherwise the cut job will begin in the middle of the media when using VersaWorks Dual and CutStudio.
Details
Symptom
I have to "unsetup" after each cut job otherwise the cut job will begin in the middle of the media when using VersaWorks Dual and CutStudio.
Cause
The cut job is beginning where the tool carriage last stopped.
Solution
When sending the cut job to the CAMM-1 GR cutter in VersaWorks Dual, be sure to enable "Return to Origin After Cut". In CutStudio enable the "Back to Origin" setting. This setting is found uner the cutter's properties. Go to "File - Cutting - Change - Change". Then go to the Options tab and under "Blade Location After Cutting", enable "Back to Origin."
I have to "unsetup" after each cut job otherwise the cut job will begin in the middle of the media when using VersaWorks Dual and CutStudio.
Cause
The cut job is beginning where the tool carriage last stopped.
Solution
When sending the cut job to the CAMM-1 GR cutter in VersaWorks Dual, be sure to enable "Return to Origin After Cut". In CutStudio enable the "Back to Origin" setting. This setting is found uner the cutter's properties. Go to "File - Cutting - Change - Change". Then go to the Options tab and under "Blade Location After Cutting", enable "Back to Origin."
Modified
April 27, 2020