Technical Support for
LV-180 Laser Engraver/Cutter
Featured Articles
Search LV-180 Documents & Knowledge Base Articles
Expand All | Collapse All
Application Resources ( 5 )
This document will help you improve the quality of your wood engraving. We will start by covering some wood characteristics and types. Then we will talk about some techniques and helpful tips/strategies.
239.68 KB
How to application guide for bridge cutting on the LV-180 LV-290 Laser Engraver
919.96 KB
How to guide for stamp mode application on the LV-180 LV-290 Laser Engraver Series
361.12 KB
This workflow will teach you how to set up your file in Adobe Illustrator for printing on a Roland LEF2-300 and cutting on the LV-290 laser engraver.
4.64 MB
Driver ( 2 )
Windows 10
FAQ ( 1 )
Maintenance & Calibration Guides ( 4 )
In this document you will learn how to gain access to all optic mirrors for the cleaning process. There are four mirrors in each of the Roland Laser Systems.
515.76 KB
In this document, we will be covering on to make sure your cutting table is in correct alignment. You will need to do this process after each time your have removed the cutting table for cleaning.
528.75 KB
In this document you will learn the proper technique to inspect & clean the focusing lens in your Roland LV Laser.
251.91 KB
In this document you will learn the proper technique to clean the SmartPIN in your Roland LV Laser. After removing the SmartPIN, you should inspect it for smoke residue or debris. If any residue or debris is present, clean the SmartPIN as follows.
225.10 KB
Owner & User Manual ( 1 )
The LV-180 Users Manual will cover how to get started, installation, basic operation, basic engravingcutting knowledge, important maintenance procedures and troubleshooting.
11.10 MB
Setup & Install Guides ( 1 )
LV-180 Unpacking installation guide. Includes accessory checklist
756.15 KB
Software Updates ( 1 )
Swatch Book for Adobe Illustrator - LV180/LV290
624.00 bytes
Training Videos ( 1 )
This video will show you how to setup and cut a basic engrave/cut job out of Adobe Illustrator.
10.18 MB
Knowledge Base Articles ( 7 )
HELP!! I can't find the driver I need for my Roland!
Recommended settings for most media.
How long do the laser tubes in the LV devices last?
Steps for testing and printing permanent marking on most metals using LaserBond 100 Laser Marking Aerosol
Description of the three focusing lenses and the differences between them.
All Roland devices with a USB, Parallel (LPT), or Serial (COM) port need a driver to communicate with a computer. For Roland products compatible with Apple Macintosh operating systems, a plugin is used with Adobe Illustrator. For Roland devices with an Ethernet port, the output software (e.g. - RIP)includes the driver as part of the application.
When outputting a design to your engraver or milling machine, the software needs to be able to translate commands to the device. These commands tell the machine how fast to mill, at what revolutions per minute (RPM), and where to mill in 3D space. This is what makes up a toolpath. A Strategy is a combination of tool movements, material properties, software algorithms, and tool characteristics.