DWX-42W Wet Dental Mill (Wood Crate)

"105E-0000" The pressure of the compressed air is too high or low

"105E-0000" The pressure of the compressed air is too high or low.

Situation/Error Cause

• Compressed air is not being supplied.
• The regulator settings are incorrect.

Procedure

1. Adjust the regulator so that compressed air with the appropriate pressure (0.18 MPa to 0.22 MPa) can be supplied. "Setup Guide"
2. According to the situation, perform the operations shown below.

• When the error occurred during milling
  • Press the operation button on the built-in panel. Milling will resume.
• When the error occurred outside of milling
  • Hold down the operation button on the built-in panel. This will clear the error.

April 30, 2020