Base de conocimientos Article
TrueVIS SG-540 54" Printer/Cutter
Cargo
Using Hard-to-Dry Media
Síntoma
The ink is not drying very well even with higher heater temperatures
Solución
Symptom
The ink is not drying very well even with higher heater temperatures
Cause
Some materials might need more time for the ink to cure properly.
Solution
Changing the scan interval time can help to allow for proper curing.
This setting is used to extend the drying time when the ink dries poorly even if the dryer is used.
1. Press MENU.
2. Press ▼ several times to display the screen shown below.
_______________________
MENU ▼
SUBMENU ▶
_______________________
3. Press ▶, then ▼ to display the screen shown below.
______________________
SUB MENU ▼
SCAN INTERVAL ▶
______________________
4. Press ▶ to display the screen shown below.
______________________
SCAN iNTERVAL ▼
OFF ▶ OFF ▶
______________________
5. Press ▲ or ▼ to select a value in seconds.
Larger values cause the media to move more slowly, enabling you to extend the drying time accordingly.
6. Press ENTER to confirm your entry.
7. Press MENU to go back to the original screen.
Note:
Default setting: OFF
Depending on the software RIP you are using, you can also make this setting in the software RIP. When you have made the setting in the software RIP, the printer's setting is ignored.
Modificado
April 09, 2020