Article | Roland
  1. Home
  2. Roland DGA Care Service & Support
  3. Print & Print/Cut
  4. TrueVIS SG-300 Printer/Cutter
  5. Article
Support Home      Warranty Registration      Email Support      User Forums
Knowledge Base Article

TrueVIS SG-300 30" Printer/Cutter

Title
Using Hard-to-Dry Media
Summary
The ink is not drying very well even with higher heater temperatures
Details

Symptom
​The ink is not drying very well even with higher heater temperatures

Cause
​Some materials might need more time for the ink to cure properly.

Solution
Changing the scan interval time can help to allow for proper curing.
This setting is used to extend the drying time when the ink dries poorly even if the dryer is used.
 
1.       Press MENU.
2.       Press ▼ several times to display the screen shown below.
_______________________      
           MENU                           ▼
           SUBMENU                 ▶       
           _______________________
 
3.       Press ▶, then ▼ to display the screen shown below.

                       ______________________     

           SUB MENU                  ▼
           SCAN INTERVAL    ▶       
           ______________________
4.       Press ▶ to display the screen shown below.
             ______________________     
  SCAN iNTERVAL  ▼
  OFF   ▶    OFF      ▶  
  ______________________
5.       Press ▲ or ▼ to select a value in seconds.
Larger values cause the media to move more slowly, enabling you to extend the drying time accordingly.
6.       Press ENTER to confirm your entry.
7.       Press MENU to go back to the original screen.

 

Note:
Default setting: OFF
Depending on the software RIP you are using, you can also make this setting in the software RIP. When you have made the setting in the software RIP, the printer's setting is ignored.
 

 

Modified
April 09, 2020
TOP