Article | Roland
Knowledge Base Article

Modela Pro MDX-650 3D Milling Machine

Title
Holding Z Axis values
Symptom
After operating "Z CENTER MODE", the end mill is placed on ASSY Sensor attemting a cut. But whenever it cuts, the Z axis values per cut are all different.
Cause
​Incorrect Z-Axis settings
Solution

Please try to perform [ Z-AXIS CENTER OFFSEADJUSTMENT].

Even if you still have a problem, please try to re-install the ZCL-650 to the MDX-650 and then perform the adjustment.

Note: There is the possibility to cut the data more precisely with using G-Code. If you use the G-Code, the MDX-500 can cut something with the mechanical resolution

     

 
Applies To
MDX-500, MDX-650, MDX-650A
Modified
March 04, 2014