Article | Roland
Knowledge Base Article

DWX-52DC 5-Axis Dental Milling Machine With Automatic Disc Changer

Title
Correcting the Milling Machine
Summary
Correcting the Milling Machine
Details

The accuracy of the milling machine may change if it is used for a long period of time or the surrounding environment changes. Performing automatic correction will correct the ATC magazine and rotary axis positions.

Situations Requiring This Work 
• When installing the machine
• When replacing the spindle unit
• When the milling position is misaligned
• When symptoms such as a level difference or a hole in the Z direction occur in the milling results Required Items

Calibration.png
Install the detection pin.

  1. Clean off any milling waste around the clamp. " P.59 "Cleaning after Milling Finishes"
  2. Use the included cloth for care to wipe clean locations 1 and 2 in the figure shown below. If any dirt is present in these locations, it may not be possible to perform the correction properly.Calibration2.png
  3. Use the included cloth for care to wipe clean the automatic correction jig and the detection pin. If any dirt is present in these locations, it may not be possible to perform the correction properly.Calibration3.png
  4. Load the detection pin in the ATC magazine's number 15 position. Insert the detection pin firmly.Calibration4.png
Modified
December 15, 2021