Article | Roland
Knowledge Base Article

DWX-52D 5-Axis Dental Milling Machine

Title
The Cleaning Tool Is Not Effective
Summary
The Cleaning Tool Is Not Effective
Details
Is the cleaning tool effective for the workpiece being milled?
The cleaning tool is effective for the following workpieces. Zirconia, composite resin, and CoCr sintered metal. User's Manual Page 38

Is the milling bur holder installed in the correct position?
The position in which to install the holder to the cleaning tool differs from the position in which to install the milling bur. Install the milling bur holder in the correct position. User's Manual Page 38

Have the bristles of the cleaning tool spread out?
If the cleaning tool bristles spread out, the tool's effectiveness at removing milling waste will be reduced. If the bristles have spread out, replace the cleaning tool with a new one. User's Manual Page 51

Is the detection pin properly attached?
The cleaning tool uses the length of the detection pin as a reference. Check the position of the milling bur holder on the detection pin. Refer to the "Setup Guide" ("Dimensional Drawings" (Detection Pin Dimensions) ). If the milling bur holder is not installed in the correct position, install the milling bur holder in the correct position, and then perform the automatic correction.
Modified
April 28, 2020