Article | Roland
Knowledge Base Article

DWX-52D 5-Axis Dental Milling Machine

Title
No Data Is Being Output to the Machine, or the Machine Will Not Operate Even Though Data Is Being Output
Summary
No Data Is Being Output to the Machine, or the Machine Will Not Operate Even Though Data Is Being Output
Details
Is the front cover open?
If the front cover is open, the machine will not start milling even if milling data is being received. Close all of the covers and press the operation button to start milling.

Does VPanel recognize the machine?
Verify that a message other than "OFFLINE" is shown in VPanel.

If multiple machines are connected, is the correct machine selected?
Select the machine to output milling data to on the VPanel screen.

Is operation paused?
Operation is paused if the PAUSE LED is lit. When the ma-chine is paused, milling stops and some operations are restricted. Pressing the operation button of the machine will cancel the pausing of operations. Holding down the operation button will abort milling.

Is initialization or a data cancel in progress?
Milling data received during the initial operations or during a data cancel will be cancelled. Make sure to output milling data after confirming that the machine is in the standby status.

Is the milling data correct?
Check the milling data.

Has an error occurred?
The ERROR LED will flash if an error occurs. A description of the error is displayed in VPanel. Responding to Error Messages
Modified
April 28, 2020