Article | Roland
  1. Home
  2. Roland DGA Care Service & Support
  3. Dental CAD/CAM
  4. DWX-43W Wet Milling Solution
  5. Article
Support Home      Warranty Registration      Email Support      User Forums
Knowledge Base Article

DWX-43W

Title
102A-0000The spindle experienced an overload
Summary
102A-0000The spindle experienced an overload.
Details
Situation/Error Cause 1
  • The spindle unit is overloaded.
  • The milling bur is worn.
  • A workpiece that cannot be milled by the machine is being used.
  • The milling conditions are too strict.
 
Procedure
  1.  Turn off the power.
  2.  Check the milling bur, the workpiece, and the CAM settings as well as the shape specified in the CAD data.
  3.  Allow the machine to rest for some time before turning the power on.
    The motor may have overheated.
Situation/Error Cause 2
  • Milling waste has adhered to the spindle.
 
Procedure
  1.  Turn off the power.
  2.  Allow the machine to rest for some time before turning the power on.
    The motor may have overheated.
  3.  Perform spindle run-in.
    Perform Spindle Run-in
Situation/Error Cause 3
  • Coolant is not applied to the middle of the milling bur.
 
Procedure
  1.  Turn off the power.
  2.  Allow the machine to rest for some time before turning the power on.
    The motor may have overheated.
  3.  Clean the coolant nozzles.
    Cleaning the Coolant Nozzle
If the Error Occurs Again

There is a possibility that the spindle unit is defective.

To replace the spindle unit, contact your authorized DGSHAPE Corporation dealer.

 
RELATED LINKS
Modified
March 20, 2025
TOP