Knowledge Base Article
DWX-43W
Title
1022-****The X milling bur was not found
Summary
X indicates a milling bur stocker number from 1 to 7.
Details
| The milling bur has not been set or it may have been set on an incorrect stocker number. |
Procedure
- Load the milling bur in the correct position again.
- Clearing Errors
-
If the error occurred during milling
- Press the operation button on the built-in panel.
- Milling will resume.
-
If the error occurred while the machine was on standby
- Hold down the operation button on the built-in panel.
- This will clear the error.
-
|
There is a possibility that the ATC magazine is out of position. Perform automatic correction. Correcting the Milling Position |
|
The collet may have worn out. Replace the collet. Replacing Consumable PartsIf the error occurs again even after you replace the collet, replace the spindle unit. To replace the spindle unit, contact your authorized DGSHAPE Corporation dealer. |
Modified
March 20, 2025