Article | Roland
Knowledge Base Article

DWX-4 4-Axis Dental Milling Machine

Title
"103B-0000" The automatic correction is not yet finished
Summary
"103B-0000" The automatic correction is not yet finished.
Details
Situation/Error Cause
  • Automatic correction has not been performed.
  • Automatic correction was cancelled before it could finish.
  • Automatic correction was not performed after updating the firmware to a version that required automatic correction to be performed again.
  • The versions of VPanel and the machine's firmware do not match.
Procedure
  1. Hold down the operation button on the built-in panel.This will clear the error.
  2. Download the latest versions of VPanel and the machine's firmware, and then install these versions.If you have already upgraded the version, proceed to the next step."DGSHAPE Corporation website (http://www.dgshape.com/) 
  3. Perform automatic correction."P. 56 "Correcting the Milling Machine" 
Modified
April 30, 2020