DWX-4 4-Axis Dental Milling Machine

"101D-000*" The % milling bur cannot be released

"101D-000*" The % milling bur cannot be released. The milling bur stocker number (1 to 7) is displayed for %.

Situation/Error Cause 1

• The ATC magazine is dirty
• The inside of the collet is dirty

Procedure

1. Follow the instructions in the VPanel window to open the collet and remove the milling bur.
2. Clean the ATC magazine. "P. 51 "Cleaning after Milling Finishes"
3.  Perform collet maintenance."P. 44 "Collet Maintenance, Cleaning of Dummy Pin, and Checking of Coolant Flow Rate"

Situation/Error Cause 2

• The stocker is out of position

Procedure

1. Follow the instructions in the VPanel window to open the collet and remove the milling bur.
2. Perform automatic correction. "P. 56 "Correcting the Milling Machine"

If the Error Occurs Again

• The collet is deformed.

Procedure

1. Replace the collet."P. 83 "Replacing the Collet"
2. Perform automatic correction."P. 56 "Correcting the Milling Machine"

April 30, 2020