CAMM-1 GR-540 Large Format Cutter Knowledge Base Article | Roland DGA
  1. Home
  2. Roland DGA Care Service & Support
  3. Cutting
  4. CAMM-1 GR-540 Large Format Cutter
  5. Article
Support Home      Warranty Registration      Email Support      User Forums
Knowledge Base Article

CAMM-1 GR-540 54" Large Format Cutter

Title
Tool Carriage Doesn't Return to Home
Summary
The tool carriage does not return to the home position after cutting a job and the control panel reads a width that is smaller than the actual width of the material.
Details

Symptom
The tool carriage does not return to the home position after cutting a job and the control panel reads a width that is smaller than the actual width of the material.

Cause
​Incorrect width value

Solution
​Unlike a Roland printer, the CAMM-1 GR cutter control panel displays the coordinates of the blade holder and where it is positioned. To clarify, the width value displayed on the control panel is the distance from the right end of the cutting area to the location where blade rests. After the cutting is finished, the carriage stays as is and shows the coordinates of the blade. This is different from Roland printers where the control panel shows the maximum printable width. The user can simply send their next job without having to select “unsetup”.
Modified
April 02, 2020
TOP