Article | Roland
  1. Inicio
  2. Servicio y Soporte Roland DGA Care
  3. Fresado
  4. Modela Pro MDX-650A 3D Milling Machine
  5. Article
Página de Inicio de Soporte      Registro de Garantía      Enviar E-mail a Soporte      Foros de Usuario
Base de conocimientos Article

Modela Pro MDX-650A 3D Milling Machine

Cargo
The spindle gets stuck while cutting when increasing the RPMs during the cutting. It is not due to the cutting depth
Síntoma
The spindle gets stuck while cutting when increasing the RPMs during the cutting. It is not due to the cutting depth
Solución

Symptom
The spindle gets stuck while cutting when increasing the RPMs during the cutting. It is not due to the cutting depth

Cause
​There could be multiple reasons for this

Solution

  1. Clean around the ball screw and LM guide.

  2. Replace the spindle and retest.

    MDX-650A is not designed for milling hard metal. Therefore, if milling Copper, Roland recommends using the MDX-650A with the suitable conditions. If you use the MDX-650A in extreme conditions the spindle will be worn out before the referential time for the replacement.
    If milling copper, the copper tends to have conducting properties. Therefore, milling copper dust might cause the short problem.

Modificado
April 08, 2020
ARRIBA