Base de conocimientos Article
Modela MDX-50 3D Milling Machine
Cargo
Holding Z Axis values
Síntoma
After operating "Z CENTER MODE", the end mill is placed on ASSY Sensor attemting a cut. But whenever it cuts, the Z axis values per cut are all different.
Solución
Symptom
After operating "Z CENTER MODE", the end mill is placed on ASSY Sensor attemting a cut. But whenever it cuts, the Z axis values per cut are all different.
Cause
Incorrect Z-Axis settings.
Solution
After operating "Z CENTER MODE", the end mill is placed on ASSY Sensor attemting a cut. But whenever it cuts, the Z axis values per cut are all different.
Cause
Incorrect Z-Axis settings.
Solution
Please try to perform [ Z-AXIS CENTER OFFSEADJUSTMENT].
Even if you still have a problem, please try to re-install the ZCL-650 to the MDX-650 and then perform the adjustment.
Note: There is the possibility to cut the data more precisely with using G-Code. If you use the G-Code, the MDX-500 can cut something with the mechanical resolution
Modificado
May 13, 2020