Article | Roland
  1. Inicio
  2. Servicio y Soporte Roland DGA Care
  3. Sistemas CAD/CAM Dentales
  4. DWX-42W Wet Dental Mill
  5. Article
Página de Inicio de Soporte      Registro de Garantía      Enviar E-mail a Soporte      Foros de Usuario
Base de conocimientos Article

DWX-42W Wet Dental Mill (Wood Crate)

Cargo
"1029-" The spindle experienced an overload.
Síntoma
"1029-0000" The spindle experienced an overload.
Solución
Situation/Error Cause 1
  • The milling bur is worn.
  • A workpiece that cannot be milled by the machine is being used.
  • The milling conditions are too strict
Procedure
  1. Turn off the power.
  2. Check the milling bur, the workpiece, and the CAM settings as well as the shape specified in the milling data.
  3. Allow the machine to rest for some time before turning the power on. The motor may have overheated.

Situation/Error Cause 2
  • Milling waste has adhered to the spindle.
Procedure
  1. Perform spindle run-in (long). "P. 95 "Spindle Run-In (Long)"

If the Error Occurs Again
There is a possibility that the spindle unit is defective. To replace the spindle unit, contact Roland DGA Corporation.
Modificado
April 30, 2020
ARRIBA