Article | Roland
  1. Inicio
  2. Servicio y Soporte Roland DGA Care
  3. Sistemas CAD/CAM Dentales
  4. Fresadora Dental Compacta DWX-4 de 4 Ejes
  5. Article
Página de Inicio de Soporte      Registro de Garantía      Enviar E-mail a Soporte      Foros de Usuario
Base de conocimientos Article

DWX-4 4-Axis Dental Milling Machine

Cargo
"105E-0000" The pressure of the compressed air is too high or low
Síntoma
"105E-0000" The pressure of the compressed air is too high or low.
Solución
Situation/Error Cause
  • Compressed air is not being supplied.
  • The regulator settings are incorrect.
Procedure
  1. Adjust the regulator so that compressed air with the appropriate pressure (0.18 MPa to 0.22 MPa) can be supplied. "Setup Guide"
  2. According to the situation, perform the operations shown below.
  • When the error occurred during milling
    • Press the operation button on the built-in panel. Milling will resume.
  • When the error occurred outside of milling
    • Hold down the operation button on the built-in panel. This will clear the error.
Modificado
April 30, 2020
ARRIBA