Base de conocimientos Article
CAMM-1 GS-24 24" Desktop Vinyl Cutter
Cargo
Media not holding down enough on the GS-24
Síntoma
I can see the material lifting up on the platen. Tracking issues.
Solución
Symptom
I can see the material lifting up on the platen. Tracking issues.
Cause
It might not have enough vacuum platen fan power with this heavier weighted material.
Solution
Press the menu button several times to display UNSETUP
I can see the material lifting up on the platen. Tracking issues.
Cause
It might not have enough vacuum platen fan power with this heavier weighted material.
Solution
Press the menu button several times to display UNSETUP
Press the down arrow until you see OTHERS on the panel
Press right arrow
Press down arrow until you see VACUUMFAN AUTO
Press right arrow to enter that command
Using the up down arrow you can change the speed of the fan
1 is Weak and 5 is Strong. Or you can use the auto setting.
Auto Setting will increase or decrease the fan speed depending on the width of the material it senses. Narrow sheet will increase the fan speed. Full width material will decrease the fan speed.
Modificado
May 11, 2020