Article | Roland

Modela MDX-40A 3D Milling Machine

Cargo
MDX-40A Spindle will not rotate
Síntoma
No spindle rotation on my MDX-40A
Solución
Symptom
​No spindle rotation on my MDX-40A.

Cause
​Refer to the following suggestions.

Solution

​1. The spindle will not rotate if the front cover is open. Built in safely feature.

2. Too much cutting waste around the spindle assembly. Refer to the MDX-40A Users Manual Page 76, "Maintenance".

3. Check the VPanel settings- in the VPanel click [Setup], then click [Modeling Machine] tab.  Finally select

[Control spindle via commands] check box.

Modificado
May 13, 2020