DWX-43W Wet Milling Solution

Cargo

105E-0000The pressure of the compressed air is too high or low

Síntoma

105E-0000The pressure of the compressed air is too high or low.

Solución

**Situation/Error Cause**
Compressed air is not being supplied. The regulator connection or pressure setting is incorrect. The knob at the bottom of the regulator is open.

Procedure

Adjusting the pressure of the compressed air.

Adjust the supplied air pressure to 0.18 to 0.22 MPa.
Clearing Errors
- If the error occurred during milling
  - Press the operation button on the built-in panel.
  - Milling will resume.
- If the error occurred while the machine was on standby
  - Hold down the operation button on the built-in panel.
  - This will clear the error.

Modificado

March 19, 2025