Knowledge Base Article
DWX-53D
Title
DWX-53DC[103B-0000][The automatic correction is not yet finished.]
Summary
[103B-0000][The automatic correction is not yet finished.]
Details
[103B-0000][The automatic correction is not yet finished.]
Situation/Error Cause 1
• Automatic correction has not been performed.
• Automatic correction was canceled before it could finish.
• Automatic correction was not performed after updating the firmware to a version that required automatic correction to be performed again.
Procedure
1. Hold down the touch sensor on the built-in panel.
Situation/Error Cause 2
The versions of VPanel and the machine's firmware may not match.
Download the latest versions of VPanel and the machine's firmware, install these versions, and then perform automatic correction.
RELATED LINKS
・ http://www.dgshape.com/
Situation/Error Cause 1
• Automatic correction has not been performed.
• Automatic correction was canceled before it could finish.
• Automatic correction was not performed after updating the firmware to a version that required automatic correction to be performed again.
Procedure
1. Hold down the touch sensor on the built-in panel.
This will clear the error.
2. Perform automatic correction.
P. 85Correcting the Milling Position
Situation/Error Cause 2
The versions of VPanel and the machine's firmware may not match.
Download the latest versions of VPanel and the machine's firmware, install these versions, and then perform automatic correction.
RELATED LINKS
・ http://www.dgshape.com/
Modified
September 14, 2022